Size
2¾" dial
Scale length
7" through one pointer revolution
Range
To 100 psia
Accuracy
0.33% of full scale
Sensitivity
0.2% of full scale
Case pressure and volume
150 psig, maximum, and 179 cc
Maximum case leak rate
Will not exceed 0.645 x 10-5 std cc/sec or 0.0019 psi/hr
Case connection
⅛" female NPT with built-in stainless steel filter
Case construction
Anodized aluminum with tempered-glass window
Flush mounted by four mounted screws through the bezel
Material exposed to measured gas
Aluminum, Beryllium copper, brass, stainless steel, nylon, Hypalon, Monel, lead, nickel-plated phosphor bronze, soft or silver solder, synthetic sapphire, paper, epoxy cement, TFE, nickelsilver, nickel plating, drawing ink, lacquer
Options
Calibration in most metric units available at no extra cost. Other units of calibration and excess-pressure-relief valves for 2, 15, and 100 psig are available at extra cost.
Weight and shipping weight
App. 2 lbs.
Order Information
When ordering, please specify ordering number, range, and mounting angle (extra cost if mounting angle is other than vertical). Options as listed above.
Note: This gauge should not be used for corrosive gases or for liquids of any kind.